![SCHENKER WATERMAKER MODULAR 300 - Capacity 300 Lt/h with Energy Recovery System device SCHENKER WATERMAKER MODULAR 300 - Capacity 300 Lt/h with Energy Recovery System device](https://www.manelservice.com/21293-large_default/schenker-watermaker-modular-300-digital.jpg)
![SCHENKER WATERMAKER MODULAR 300 - Capacity 300 Lt/h with Energy Recovery System device SCHENKER WATERMAKER MODULAR 300 - Capacity 300 Lt/h with Energy Recovery System device](https://www.manelservice.com/21293-large_default/schenker-watermaker-modular-300-digital.jpg)
Consumpition: 2000 W
Power supply: 230 or 380 VAC
Capacity: 300 Lt/h - 79 Gal/h
Membranes: n.3 4'' x 40''
Remote panel: Digital
Length: 1281 mm
Width: 587 mm
Height: 422 mm
Weight: 145 Kg
SCHENKER MODULAR 300 DIGITAL INVERTER is a watermaker equipped with three membranes of 4'' x 40'' thanks to which it can deliver 300 l/h of osmosis water.
The indicated flow rates are nominal and therefore may vary by ±20% depending on actual operating conditions. Thanks to the very low power consumption, the watermaker can be powered directly from the batteries. It is possible to install the watermaker even without a generator set.
Thanks to the 80% lower power consumption and the lack of a generator set, the CO2 emissions required for water production are reduced by more than 85%. Only the SCHENKER MODULAR 300 DIGITAL INVERTER allows you to make water and truly respect the environment.
Operation of the SCHENKER MODULAR 300 DIGITAL INVERTER is extremely simple, as no adjustment is required. In fact, all systems are equipped with automatic pressure regulation. No direct access to the watermaker is required. All functions are performed remotely via the remote panel.
The SCHENKER MODULAR 300 DIGITAL INVERTER does not use high-pressure pumps. The result is an extremely quiet operation and a total absence of vibrations. The parts of the watermaker that come into contact with seawater are mostly carbon fibre or acetal resin. The SCHENKER MODULAR 300 DIGITAL INVERTER is therefore totally corrosion-free.
In the 2.0 systems, all components potentially subject to wear such as o-rings and conventional hydraulic seals have been eliminated. The sealing and sliding elements are made with innovative pads made with nano-technologies. These materials exhibit an abrasion resistance up to 15 times higher than steel.
SCHENKER MODULAR 300 DIGITAL INVERTER systems use the new patented ENERGY RECOVERY SYSTEM® as an alternative to the high-pressure pumps of conventional systems. This system amplifies the pressure provided by low-pressure pumps, enabling extremely high energy efficiency. The typical power consumption of a SCHENKER MODULAR 300 DIGITAL INVERTER is only 4 Watth/liter.
The ERS is designed specifically for marine applications and is made of materials that are completely impervious to salt water. Moving parts are kept to a minimum, thanks to the patented solution that eliminates the need for pilot valves.
Kit contents:
- Watermaker with Energy Recovery System
- Feed pump with seawater filter
- Activated carbon filter with solenoid valve
- Mains filter with seawater inlet
- Filter wrench
- Check valve
- Freshwater production hose (5 meters)
- Remote panel
- Installation kit (assortment of screws and fittings)
- Instruction manual
Standard functions:
- Automatic pressure adjustment
- High pressure lockout
- Low pressure lockout
- Failure to cycle lockout
- Minimum voltage lockout
Remote control functions:
- Remote start/stop
- Timer
- Automatic wash
- Intensive wash
- Periodic wash
- Automatic start-up
- Hour meter
- Assisted maintenance
CARACTERISTICS TCNICHE SCHENKER MODULAR 300 DIGITAL INVERTER
Power: 2000 W
Power supply: 230 or 380 VAC
Flow rate: 300 Lt/h
Membranes: n.3 4'' x 40''
Control panel: Digital
Length: 1281 mm
Width: 587 mm
Height: 422 mm
Weight: 145 Kg
Are you looking for a watermaker with different technical characteristics? WHERE you can find the full range of watermakers from SCHENKER or other specialized brands
Pictures and technical data are not binding